SyferLock Help Center

Adding a Network Interface to a Hypervisor

Pre-Requisites

Note:

  1. Complete first time setup with a single network interface card before adding the second one.
  2. Power off GridGuard server before adding the Network Interface

These instructions are for VMWare ESX/ESXi; for other hypervisors, improvise as necessary.

Edit Virtual Machine Configuration

Edit Virtual Machine Configuration

Click Edit Settings for the virtual appliance and click the Add button on the Hardware tab

Add Ethernet Adapter

Add Ethernet Adapter

Choose Ethernet Adapter from the list of devices and click Next

Choose Network Type

Choose Network Type

Set the Adapter Type to e1000, if available. If not, choose Flexible.
Set Network Connection as required.
Ensure Connect at power on is checked.
Click Next

Finish Adding Network Adapter

Finish Adding Network Adapter

Click Finish to complete network adapter setup

Save Changes

Save Changes

You will now see an entry for the New NIC (adding). Click OK to save changes

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk